Community Updates

Eastman and Lubrizol collaborate to elevateTPE overmolding adhesion with sustainable materials

The collaboration stemmed from a mutual recognition of overmolding's importance in manufacturing while delivering improved product performance and aesthetics in consumer goods when using Eastman’s sustainable material, Tritan™ Renew, and Lubrizol’s ESTANE® ECO, renewably sourced TPU.

By Eastman | Published 6 months ago | About a 1 minute read

The companies researched how specific processing variables impact the adhesion strength of overmolded samples produced through 2K injection molding. The study’s findings are believed to be applicable across various TPE and substrate combinations. This is of particular interest when mechanical interlocks cannot be used and material changes are not feasible but improvements in adhesion strengths are desired.

By optimizing key TPE processing variables like mold temperature, pack and hold time, and TPE barrel temperature, the research team achieved a notable 124% improvement in adhesion strength compared to values obtained using nonideal processing conditions. An additional improvement in adhesion strength was observed when Lubrizol’s ESTANE® ECO 12T80E and 16T85 TPU grades were used. These grades displayed the highest peel strength values (> 310 N) of all TPEs evaluated in this preliminary study.

“This was a unique opportunity for two leading material companies to leverage sustainable multi-material solutions that enable customer innovations and expand the limits of consumer product experiences,” said Vince Haas, Lubrizol’s engineered polymers senior business director.

Read full story here.